Fuel Savers Reduced Emissions Tests
    MAXPower Fuel Savers - The Science Contd.

The technical explanation

When a hydrocarbon fuel (methane molecule) is combusted, the first to be oxidised are the hydrogen atoms (electrons on their outer shells). Only then the carbon atoms are subsequently burned. Since it takes less time to oxidise hydrogen atoms in a high speed internal combustion process, in normal conditions some of the carbon will be only partially oxidised, which is responsible for the incomplete combustion. Oxygen combines with hydrogen readily, however the carbon-oxygen reaction is far less energetic - we should keep in mind: oxygen alwasy has a valance of minus two. The valance of carbon on the other hand can be plus or minus due to the configuration of its four electrons in the outer shell, which requires a total of eight electrons for completion.

The optimum combustion efficiency (performance) obtained from the MAXPower application on fuel is first indicated by the amount of increase in carbon dioxide (CO2) produced, which has been validated by official emission control devices. As the pollutants decrease, the combustion efficiency increases proportionally. The reduction of HC and CO emissions is easily proved by comparative gas flue analysis and opacimeter emissions tests.

Ethos MAXPower Super Fuel Saver

MAXPower units convert fuel molecules to a positive charge and sets them in order, which increases the attraction of the negatively charged air molecules. The highest burning efficiency will be achieved at the highest carbon dioxide level, since carbon dioxide cannot be subsequently oxidised.      

The Internal Combustion Engine

 Petrol & Diesel Fuel Savings

Fuel inside the cylinder is ignited by an electrical spark from the spark plug.

The fuel combusts very rapidly creating a force which pushes the piston down and makes the crankshaft turn.

This crankshaft motion is then transferred through various gearing to the wheels and makes the car move.

Therefore, you have a finite time taken for a piston to go down and up again for the combustion process to take place.

Whatever fuel remains un-burnt during this finite time is wasted and is expelled in the exhaust gases as hydrocarbons. These can be measured using an exhaust gas analyser as used during the MOT test ~ too high a level and the vehicle will fail.

When you fit a MAXPower fuel conditioner, its powerful magnetic field excites the fuel causing it to combine more readily with the oxygen in the air leading to a more efficient transfer of energy when it is burnt.

Exactly the same amount of fuel goes into the cylinder but it is burnt more completely during the same finite amount of time.

MAXPower creates more energy/power from the same given volume of fuel and will work with any hydrocarbon based fuel including petrol. diesel, gas and oil.

If you use that extra energy up ~ you dont save any money !

If your driving style remains unaltered then you save money !!


 *Buy Now*

 [ The Science ] [ Technical Explanation ] [ FAQs ] [ Installation Guide ]  [ Guarantees ]